Eldes ESIM264 Instrukcja Instalacji Pobierz pdf (Strona 110)

110

Fig. No. 38

2.3 The sensor should be attached to the xed sensors mounting part. When attaching sensor pay attention to the tamper

(micro switch) - it must be pressed.

2.4 The magnet cover should be attached to the xed magnet mounting part.

NOTE: It is not recommend to x EWD1 in other ways than with screws, e.g. with duck tape.

See Fig. No. 38 for the incorrect ways of xing the magnetic door contact.

3. Bind the device to ESIM264 alarm. Use a software ELDES Conguration Tool or send corresponding SMS messages. Please

refer to software‘s HELP section or refer to chapter 8. ELDES Wireless Devices for more details.

4. The system automatically informs about successful/unsuccessful binding process. If attempt to bind is unsuccessful, try to

move EWD1 closer to alarm system device and bind anew.

5. EWD1 magnetic door contact is ready to use.

NOTE: If you are unable to bind the wireless device, please, restore the parameters of the wireless device to default and try

again. See chapter 8.4.5. Restoring Default Parameters for more details.

ATTENTION: The minimum wireless connection range between the wireless device and wireless antenna of EWT1 module

installed in ESIM264 system can be 0,5 meters.

8.4.3 EWD1 Zones & Tamper

Upon successful EWD1 magnetic door contact binding process,the system adds 1 wireless Instant zone and 1 wireless Silent zone.

The wireless zones are applied to the following EWD1 components respectively:

•Magneticcontact-by default, causing alarm if doors/windows is opened when system is armed.

•Panicbutton - by default, causing silent alarm instantly when pressed.

In case of tamper violation, the alarm is caused regardless of system being armed or disarmed. There are 2 ways to detect tamper

violation on EWD1:

• Bytamperbutton.EWD1 has a built-in tamper button intended for monitoring the enclosure status. Once the enclosure

of EWD1 is illegally opened, the tamper button becomes unpressed. This action is followed by alarm which is sent by SMS

message and phone call to the user (-s) by default. The SMS message contains the violated tamper number.

• Bywirelessconnectionloss. The wireless connection loss between EWD1 and ESIM264 system leads to alarm. The system identies

this event as a tamper violation and sends alarm by SMS message and phone call to the user (-s) by default. The SMS message contains

the violated tamper number and a star * character indicating wireless connection loss as a tamper alarm cause.

ATTENTION: The tamper will not operate if both wireless zones are disabled.

1 2 ... 105 106 107 108 109 110 111 112 113 114 115 ... 139 140

Brak uwag

Eldes ESIM264 Instrukcja Instalacji Strona 110