Eldes EKB3 Instrukcja Instalacji Pobierz pdf (Strona 49)

49EN

MANUAL ELDES ESIM264 V3.1

Set zone connection

type for 6-Zone mode

EKB2

Menu path:

OK → CONFIGURATION → OK → aaaa → OK → ZONES → OK → ZONE TYPE:6-ZONE M

→ OK → TYPE 1... 3 → OK

Value: aaaa – 4-digit administrator password.

EKB3

Enter parameter 39 & number of zone connection type:

39 1 # – Type 1

39 2 # – Type 2

39 3 # – Type 3

Example: 392#

Cong

Tool

This operation may be carried out from the PC using the ELDES Conguration Tool software.

14.4. ATZ (Advanced Technology Zone) Mode

The ATZ mode is a software-based feature that doubles the number of on-board zones and enables two detection devices to be installed

per 1 zone terminal. Once this mode is enabled, the zone connection Type 4 is set automatically. The detection devices must be wired to

the on-board zone terminals as indicated in the wiring diagram of the associated zone connection type. Available zone connection types

for the ATZ mode:

• Type 4 – Parallel wiring of 2 NC (normally-closed) detection devices with 5,6k and 3,3k EOL (end-of-line) resistors respectively.

5,6k EOL resistor corresponds to zones ranging from Z1 through Z6, while 3,3k EOL resistor corresponds to zones ranging from Z7

through Z12.

• Type 5 – Combination of serial and parallel wiring of tamper with 5,6k EOL resistor and 2 NC (normally-closed) detection devices with

5,6k and 3,3k EOL resistors respectively. 5,6k EOL resistor corresponds to zones ranging from Z1 through Z6, while 3,3k EOL

resistor corresponds to zones ranging from Z7 through Z12.

For zone wiring diagrams of the ATZ mode, please refer to 2.3.2. Zone Connection Types.

Enable ATZ mode

EKB2

Menu path:

OK → CONFIGURATION → OK → aaaa → OK → ZONES → OK → ATZ MODE → OK →

ENABLE → OK

Value: aaaa – 4-digit administrator password.

EKB3

Enter parameter 28 & parameter status value:

28 1 #

Example: 281#

Cong

Tool

This operation may be carried out from the PC using the ELDES Conguration Tool software.

Disable ATZ mode

EKB2

Menu path:

OK → CONFIGURATION → OK → aaaa → OK → ZONES → OK → ATZ MODE → OK →

DISABLE → OK

Value: aaaa – 4-digit administrator password.

EKB3

Enter parameter 28 & parameter status value:

28 0 #

Example: 280#

Cong

Tool

This operation may be carried out from the PC using the ELDES Conguration Tool software.

1 2 ... 44 45 46 47 48 49 50 51 52 53 54 ... 167 168

Komentarze do niniejszej Instrukcji

Brak uwag

Eldes EKB3 Instrukcja Instalacji Strona 49

Komentarze do niniejszej Instrukcji

Powiązane produkty i podręczniki dla Systemy kontroli dostępu bezpieczeństwa Eldes EKB3